How much clay?

marshon

New Member
Hi guys,

I've decided to try my hand a clay sculpt. Klean Klay is readily available here in the UK, but my question would be how much to order for a 'standard' full mask? I don't want to order too little and have to re-order to finish the sculpt. Then again I don't want to over order and have it sitting around doing nothing (not to mention the cost).

Any advice would be cool. I can do conversion, so kilos or pounds would be a guide for me.

Ta.
 
With a Armature underneath i use roughly 16-18 x2lb blocks of chavant. which is 32-36lbs. that is enough to get most sculpts big enough to fit a bio.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top