Hair punching into rigid sculpts... possible?

Mulbin

Active Member
Hi, I'm currently 3D printing Peter Cushing! Working on a full size Grand Moff Tarkin. Does anyone have any experience punching (or otherwise attaching) hair into a rigid sculpt? The challenge is that Cushing's hair was very thin and balding when Star Wars was filmed so a wig would just look awful, it needs to show a lot of scalp.
 
Generally you'll end up gluing hair onto a rigid piece. I don't think it's possible to punch. Look into how hair is laid for makeup effects.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top