Full size orc muzzle helmet LOTR

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


RoyFokker

New Member
This is my current wip, an approximately full size version of the orc cage/orc muzzle helmet. I started out in cardboard, didn't get where I wanted, ended up scrapping it and moving to insulation foam, bondo, and sculpey.

I think I am at the point that I want to make a cast, but not sure if I can use rebound over uncured sculpey. I am open to hear any feedback and suggestions.

I think I have more bondo on my back porch than I actually ended up having on the helmet itself. I don't think my arm will ever be the same after sanding that much of the stuff, ha. :cry
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top