Vrogy
Well-Known Member
This is lilykill's 10mm from thingiverse.
I printed it in purple HIPS in a few crowded rafts on a Lulzbot mini at my local hackerspace, Making Awesome.
Parts were right up on the bed extents.
Pretty smooth printed at high detail right off the bat. About 50-60 hours of printing total.
The reliability of the lulzbot mini has been very impressive so far.
I gave it a good heavy pass with 220 grit before any primer went on.
Several layers of alternating terra cotta and grey later. Very little spot putty was required.
This is after maybe 5 additional filler primer passes.
Here's the various bits set up for a gang block mold.
Added some patches of texture on the handle with textured rattlecan paint.
Molding.. sometime.
I printed it in purple HIPS in a few crowded rafts on a Lulzbot mini at my local hackerspace, Making Awesome.
Parts were right up on the bed extents.
Pretty smooth printed at high detail right off the bat. About 50-60 hours of printing total.
The reliability of the lulzbot mini has been very impressive so far.
I gave it a good heavy pass with 220 grit before any primer went on.
Several layers of alternating terra cotta and grey later. Very little spot putty was required.
This is after maybe 5 additional filler primer passes.
Here's the various bits set up for a gang block mold.
Added some patches of texture on the handle with textured rattlecan paint.
Molding.. sometime.