Darth Vader reveal mask from ROTJ

[James Hammond]

First coat of paint, at this stage it looks more like it was intended to be which was a ROTS reveal.

 

[James Hammond]

Here it is with the second coat over the black, starting to look more like the ROTJ mask.

 

[James Hammond]

Here it is with more greeblies after final paint.

 

[James Hammond]

I made the connection tabs that sit behind the tusks on the lower jaw

 

[eethan]

very nice work

 

[James Hammond]

Thanks friend, I hope to get some more done on the internal part of the lower jaw soon.

 

[James Hammond]

Vocoder speaker hats arrived, thanks bonesaredollars. Attached the wires using aluminium tubing

 

[James Hammond]

Finally getting a start on the greeblies for the inside of the lower jaw, shout out to bonesaredollars for creating the pieces I need for this build.

 

[James Hammond]

Thanks to Bengrim I was able to source some screen used mesh for the vocoder grill

 

[James Hammond]

just wondering if anyone knows the measurements, dimensions of the flat tinned copper wire braid for the inside of the lower jaw, I can easily get some online once I have the correct size???

 

[James Hammond]

getting close to putting together the lower jaw internals, completed the vocoder grill together with the riv nuts and wires.

 

[James Hammond]

The revised L shaped curves, they are bigger and they curve slightly so they fit snugly against the wall of the lower jaw.

 

[Jamesfett]

The revised L shaped curves, they are bigger and they curve slightly so they fit snugly against the wall of the lower jaw.

Wow!!!! Best I have ever seen.

 

[James Hammond]

Breather tubes along with the wires, the wires are 3mm copper with kneedit putty for the ridges covered with shrink wrap.

 

[James Hammond]

Thanks Jamesfett, I can't take credit for them, they were created by Bonesaredollars for me, his work creating props is outstanding..

 

[Jamesfett]

Thanks Jamesfett, I can't take credit for them, they were created by Bonesaredollars for me, his work creating props is outstanding..

Does he offer these?

 

[James Hammond]

I've put together the tubes for the side walls of the lower jaw using 7mm and 4mm silicone tubing and 3mm red wires. The two small tubes that sit on the bottom are made from 3mm silicone tubing ×2 and 2mm red wires. They all sit on a clear plastic backing.

 

[James Hammond]

I found that the best glue to fix them to the plastic is a silicone glue, I found cheap on ebay.

 

[James Hammond]

Sorry for the late reply Jamesfett, I've spoken to Bonesaredollars and you should be hearing from him soon.

 

[Kroenen77]

The revised L shaped curves, they are bigger and they curve slightly so they fit snugly against the wall of the lower jaw.

These are looking great...are this 3D prints or found parts?