Darth Tyrannus / Count Dooku mask


Sr Member
Hi! This is a little side project i'm working on. This is also my first 1:1 head sculpt. I recently obtained an MR Dooku as well as a Korbanth Duke hilt and wanted to build an impression to match. Unfortunately, i am genetically incapable of growing a full beard, hence the main motivation for this project.I'm using a friend's home brew oil-based clay and sculpting over a fiberglass display head. It's still very much stylized. I'm going for a miz of Christopher Lee, 2003 Microseries and TCW 3d Dooku.This is my first time making a mask so i'm very much open to suggestions re latex rubber / latex foam / silicone material.
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.