Buckaroo Banzai Overthruster and Case

Wonderful work! I've been tied up with other stuff and haven't had much progress beyond a satin clear coat on it. How'd you manage the lettering on the panel inside? The reed switch IS a great idea, and it looks like it fits the box perfectly as it could be a charging contact point!
 
Thanks for the kind words Kerr,
The lettering is 5mm and 3mm letraset rub on letters. The asian (sort of) writing was on the sticky side of packing tape cut to size. I may add some sound...not sure yet. Love to have a few beeps happening.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top