andrewp
New Member
Hi there
I scratched this black series snowspeeder cockpit from 1mm styrene since the cockpit on the toy is too thick - as has been discussed in other useful posts (eg tazman2000). just wondering if anyone could advise about how to mould and cast such a thin part or if it’s even possible or worthwhile for the community for those without a 3D printer
Cheers
I scratched this black series snowspeeder cockpit from 1mm styrene since the cockpit on the toy is too thick - as has been discussed in other useful posts (eg tazman2000). just wondering if anyone could advise about how to mould and cast such a thin part or if it’s even possible or worthwhile for the community for those without a 3D printer
Cheers