Crazy Hunter
New Member
So times on the fast my skull harness what is on the back besfestigt see AVP Chopper.
2 bamboo rods moderately at the hardware store to gekauft.2 x 85 cm length and cut to 1 x 32 cm wide.
The staff of 32 cm length is in the upper part pushed through a piece of wood and secured with hot glue.
On the sides are each one hole drilled and an 8 mm wooden stick pushed through the bamboo.
At the lower end of the same thing happens.
Then a leather stretched across whiskers, and in this you can use different teeth, bones, jaw or jewelry beads
thread.
Leather belts sat glued to the bamboo finished end.
Finally, you can paint their skulls or Unpainted sure to fix it
2 bamboo rods moderately at the hardware store to gekauft.2 x 85 cm length and cut to 1 x 32 cm wide.
The staff of 32 cm length is in the upper part pushed through a piece of wood and secured with hot glue.
On the sides are each one hole drilled and an 8 mm wooden stick pushed through the bamboo.
At the lower end of the same thing happens.
Then a leather stretched across whiskers, and in this you can use different teeth, bones, jaw or jewelry beads
thread.
Leather belts sat glued to the bamboo finished end.
Finally, you can paint their skulls or Unpainted sure to fix it
Last edited by a moderator: