AVP skull harness

Crazy Hunter

New Member
So times on the fast my skull harness what is on the back besfestigt see AVP Chopper.
2 bamboo rods moderately at the hardware store to gekauft.2 x 85 cm length and cut to 1 x 32 cm wide.

The staff of 32 cm length is in the upper part pushed through a piece of wood and secured with hot glue.
On the sides are each one hole drilled and an 8 mm wooden stick pushed through the bamboo.
At the lower end of the same thing happens.
Then a leather stretched across whiskers, and in this you can use different teeth, bones, jaw or jewelry beads
thread.

Leather belts sat glued to the bamboo finished end.
Finally, you can paint their skulls or Unpainted sure to fix it
 
Last edited by a moderator:
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top