aprilandthree

New Member
Hi all. I am an extreme newbie here, so please bear with me.
My daughter (8yo) wants to be Sabine Wren for Halloween. I make all of her costumes but this one has me stumped. What do I use for the armor and helmet?
I found a YouTube tutorial for a Mandalorian helmet using cardboard so I think I’ll take that route.
I’ve read about PVC foam board (sintra) but I’m not sure where to source it. We are in a small town and only have Hobby Lobby & Michaels. Is there an alternate material I can use that might be easier to find?
I haven’t even thought about how to make her blaster yet...
 
Punished props on YouTube has some awesome tutorials, he just released his new book as well. Might be worth checking out

Please keep us up to date on your progress Sabine is a favorite of mine

If you’re looking for a darksaber soloshold just did a limited run

Oh! And welcome to Therpf!!
 
I don't know much about eva foam, but I have seen it at Michaels with even signs saying it's good for cosplay/costume creation. Good luck and welcome!
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top