Arc Reactor Blueprints Poster Test (27x40 Using CNC as plotter)

Thread starter Op4
Start date Jun 26, 2013

Op4

Active Member

Jun 26, 2013

I got a couple of requests to make a separate thread of my arc reactor blue prints project. I have a bunch of needed materials coming for my statue project and decided to take on another project while I wait. I tried getting the Arc reactor blueprints blown up (27x40) with no luck (obvious copyright issues) so I decided to just create toolpaths from the prints from the Avengers 10 disc set and draw them out on the cnc.

I am just experimenting with cheap pens and paper. Hopefully it will turn out rustic and readable when I am done.

Here is a couple of test images. Hopefully this will encourage other people to try this with the cnc...just playing around really..

Last edited: Jun 26, 2013

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.