Anyone here making metallic adhesive sleeves for TFA Graflex?

[Crimsonnaire]

I know this is not an issue for those going the Graflex 2.0 route, but for those with vintage and replica pieces with the word Graflex on the clamp, having the adhesive sleeve is the only screen-accurate method as determined in the TFA Graflex Research thread. So is anyone here planning to make a run of these or would anyone happen to know where metallic sleeves like this can be found? Of course, cutting the slots is going to be a pain.

Is it likely that the screen-used prop uses an industrial metallic tape rather than something made by the department?

 

[SethS]

http://www.therpf.com/showthread.php?t=237477&page=69

post 1710

 

[MastahBlastah]

Also:

http://www.therpf.com/showthread.php?t=237477&page=72

Post 1781

 

[ARKM]

Um, you guys can actually link directly to the post by clicking on the post number. SHAZAM!

http://www.therpf.com/showthread.php?t=237477&page=69&p=3881775&viewfull=1#post3881775

http://www.therpf.com/showthread.php?t=237477&page=72&p=3893163&viewfull=1#post3893163

You're welcome.