Anyone have access to a large vaccuforming service

bobbyfett

Active Member
Like the title says, can anyone vacuuform a large piece for me? It's an approximately 12" plastic lens off the front of a clock that I want to replicate. It doesn't need to be clear. Please e-mail me or reply if you can help. Thanks..
 
The lens is about 12" in diameter and only about 2 inches high or so. I'm not sure of the exact measurements but it is very short.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top