am i crazy

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


Star Wars Man

Well-Known Member
i went to my local hardware store, and bought the thinnest sheet metal there.... .12"

is that really thick? am i crazy for trying to use that on a e11 blaster?
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

gavidoc

Sr Member
Depends on what you are using it for.

1/8" steel is going to be difficult to work with unless you have more then your average, every day, DIY tools.

Doable, but not as easy and more time consuming.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Star Wars Man

Well-Known Member
well my fiberglass reinforced cut off wheel did just fine, it took a while, with some sparks.....so should i walk the like 1.5, 3 all together walk to an ace hardware?
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top