Ahsoka - Mandalorian Lightsabers

[NitroTech]

Newbie here. I'm in the process of 3D printing Ahsoka's lightsabers from files I found on Thingiverse. Ahsoka Tano's Lightsabers (Rebels) by CaseStudyno8

I've printed the Shoto, short hilt, but my daughter says its too small. The main body measures 6-1/8", that I've printed. I've attached a picture depicting the same dimension.

Does anyone know if the size I'm printing at is near correct? Or what are the correct sizes?

 

[corliss1]

Here there! These are measurements from khal1993 's "Thrawn Hunter" run - I've got 10.5" on the shoto and 14" on the main:

 

[NitroTech]

Here there! These are measurements from khal1993 's "Thrawn Hunter" run - I've got 10.5" on the shoto and 14" on the main:


View attachment 1622680View attachment 1622681

Awesome! Thank you so much