3D rendering and rapid protyping? Anyone have one of these machines?

H

Hitogiri

Sr Member
I am looking to have something made but there is some fine detail involved and I was wondering if anyone here had access to a rapid prototyping machine. I know we have a few industry pros here and some hobbyist with some nice tech at their disposal.

Thanks!

Brian
 
I have an MDX-15. It is a subtractive rapid prototyping machine. Unfortunately I am very short on spare time. What do you have in mind? Do you already have it on the computer?
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Knightmare
Can anyone explain this to me are these a holy grail of replicas ?
Replies
10
Views
1,356
joberg
joberg
paulsboutique
Lacrima 99 Shock Rifle - Aliens 4- 3d design and print
Replies
14
Views
440
BrooklynGuy
BrooklynGuy
bk85
One-Eyed Willy skull and eyepatch- Advice needed, see post #5
Replies
7
Views
451
Hanamaid
Hanamaid
IndyFanChuck
Anyone 3D printed a Raiders Ark of the Covenant?
Replies
7
Views
798
IndyFanChuck
IndyFanChuck
dproc
Aliens Shoulder Lamp - Found Part and 3d Print
Replies
9
Views
1,026
joberg
joberg
Back
Top