My attempt at a HAL 9000 deactivation key. I based my design off of AP-333’s key and did a scratch build of the body in shapr3d to CNC it from 6061 aluminum. Press fit a standard Burg-Wachter E7 key and done.
Messed up one body by drilling slightly off center for the key as I didn’t leave a lot of wiggle room on either side of the shaft.
I think my dimensions are a little off (too thin and I feel like I tapered too narrow toward the top) and still needs some finishing work but I’m happy with the result.
Messed up one body by drilling slightly off center for the key as I didn’t leave a lot of wiggle room on either side of the shaft.
I think my dimensions are a little off (too thin and I feel like I tapered too narrow toward the top) and still needs some finishing work but I’m happy with the result.