Recent content by Bio

Thank you! If you have a Harbor freight near by, they sell 1/2" foam, but it has a texture on 1 side that will need removed. Most hardware stores have 1/2" and 1/4" foam. For small sheets of the 1/4" / 6mm with no texture, taht is avalible at craft stores like Michael's. Michael's will also have...

I have the blueprint avalible on my etsy page https://www.etsy.com/listing/261277375/10mm-pistol-blueprint?ref=shop_home_active_1

For this thing on the bottom of the magazine I used 2 layers of 1/2" foam. The indent was just dremeled with a round dremel bit. The front sight is a piece of 2mm craft foam, with a piece of 4mm on top. To make this disk thing I used the cap of a fine point sharpie. I just pushed and...

Here's my build of the 10mm pistol from Fallout 4! I made a blueprint in inkscape using screenshots from the game as reference. This is only my second real attempt at making a prop gun, but I think it turned out pretty good! I started off with 2 layers of 1/2" eva foam cut in the basic shape...

The collar is foam with fabric glued to it

I recently made a Destiny Warlock costume which has some bone armor. I had some requests on how I painted the bone, so I decided to make a short tutorial. This was written in a format for facebook, but hopefull it translates well here (facebook link- http://on.fb.me/1O2kUcm) The pieces I’ll be...

Here are some pictures of Batgirl! Taken by The Portrait Dude - Cosplay Photography

No this is just an original design. Color scheme is based off the new 52 batgirl

Batgirl is complete! Well, I may still may some shoe armor to cover the laces, but... complete for now! She wanted the paint scheme to look similar to the new 52 costume. There's some weathering as well, but the lighting wasn't the best so it doesn't show up here. Once I have some better...

I added ears to the cowl. The armor is just about ready to be sealed and painted! Haven't decided what I'll be sealing it with. I may just go with plastidip and a filler primer for this one

Here's a test fit with the unfinished cowl. The cowl still needs a bit of work. I'll be dremeling all the edges and may remove some foam under the eyes.

Thank you! It's just a design I sketched. I tried to find reference pictures of an armored Batgirl to base it off of, but I couldn't find much. Some of the general lines and shapes in the chest I based off the new 52 Batgirl, but I took a lot of inspiration from Halo and Mass effect armor (you...

Made the thighs today

Almost finished the the gauntlets. They're held on with tape for the photo. Also here's a look at the shoulders

I started making some Batgirl armor for my girlfriend. I started out by wrapping her in plastic wrap and covering that in duct tape. Then I drew out my design and cut it out. Next this was traced on to paper, then on to EVA foam. So far I just have attached to stomach sections with elastic so...