brulafu
Active Member
Im getting a Cantina Band member mask & gloves from thawn_es on here and the only thing I have left is the kloo horn.
This was my initial diagram
Which I then put together
Made proper 2d drawing from
and got them drawn up and modelled in 3d
My plan is to geth the basic parts 3d printed and then mould and cast them as sections so they just click together.
The first piece was test printed yesterday
I will also be installing electronics into the main piece.
I'll post a youtube link later on
This was my initial diagram
Which I then put together
Made proper 2d drawing from
and got them drawn up and modelled in 3d
My plan is to geth the basic parts 3d printed and then mould and cast them as sections so they just click together.
The first piece was test printed yesterday
I will also be installing electronics into the main piece.
I'll post a youtube link later on