Hey guys,
Apologize for being quite for a little while. Starting to ramp up some new cosplays for the year. Was really wanting to get a 3d printer to start making some pieces. Definitely entry level here. I was taking a look at the Da Vinci 3-D Printer 1.0 model from XYXPrinting. http://us.xyzprinting.com/us_en/Product/da-Vinci-1.0 Best Buy sells this model for $499.99. http://www.bestbuy.com/site/xyz-pri...gray/9667196.p?id=1219450380283&skuId=9667196. Most of the reviews out there seem to give it either a 4 out of 5 or 5 out of 5. Can't seem to find anywhere if it can read open source software. I highly doubt it. What are your thoughts?
Also I have a second question. Has any found a good printer to print out on 110lb card stock printer. We got a new canon MG7520 put the paper seems to be too think. Was wonder if laser printer would be better for that to start making some pep cosplays. Anyone have any suggestions?
Thanks
stofdaddy
Apologize for being quite for a little while. Starting to ramp up some new cosplays for the year. Was really wanting to get a 3d printer to start making some pieces. Definitely entry level here. I was taking a look at the Da Vinci 3-D Printer 1.0 model from XYXPrinting. http://us.xyzprinting.com/us_en/Product/da-Vinci-1.0 Best Buy sells this model for $499.99. http://www.bestbuy.com/site/xyz-pri...gray/9667196.p?id=1219450380283&skuId=9667196. Most of the reviews out there seem to give it either a 4 out of 5 or 5 out of 5. Can't seem to find anywhere if it can read open source software. I highly doubt it. What are your thoughts?
Also I have a second question. Has any found a good printer to print out on 110lb card stock printer. We got a new canon MG7520 put the paper seems to be too think. Was wonder if laser printer would be better for that to start making some pep cosplays. Anyone have any suggestions?
Thanks
stofdaddy
Last edited: