JBReplicas
Sr Member
Here I will document the progress on my 'X-Men First Class' Magneto Helmet, I started off with one of those cheap classic Iron Man helmets that pop up on eBay from time to time, once I'd chopped off all the bits I didn't need I set about building up the basic shape with cardboard, I then used a thin layer of filler on top of that to get it to where it is in the first picture, I roughly sketched on the pattern for the raised area around the face and bottom of the helmet and then carefully applied 2mm styrene strips to mark out the over all shape, I then went back and started filling inside these strips to build up the next layer, I am currently refining the details, at the moment its very much sand/fill/sand/fill but Its starting to take shape. I welcome any and all comments :thumbsup
Last edited: