typewriter
Active Member
Hi everyone! I just received my Silhouette Cameo today and I've done some experimenting on it. The first problem was: I couldnt get it to read my registration marks.. So after 2 hours of failed trials, I finally came across a thread in the 405th as mentioned by darkside and it turns out that there was too much light in my room. So I closed the lid of the cameo and the registration mark read 1st time around. Now 2nd problem : after it read the makrs, I proceeded to cut developments on the cameo viewer and naturally being excited, I was disappointed to see that only ONE part got cut. and the cuts weren't even close to the lines. (1-2mm off) I know its been asked, but I really dont know what to do. If someone could lend a helping hand, it would be awesome, because currently I am building Darkside's Markvii (thanks darkside). Thanks!