Can you elaborate? It's a good way to use the bad holes but In my head I picture just a larger hole shaped like "8"Just unscrew the bottom screws ... take the T-track off and then file out the remaining bottom holes just enough so you can move the T-track so that the top holes are covered again
I finally found the leftover screws from my Ranch Saber run like 10 years ago. I don't have any of the grip screws but I have the brass ones.
I've got the slotted round head screw that replaces the clamp lever. It's a weird thread and hard to come by, I can send you two.
I was told by an 'insider' I trust the screw holding the lever on was a flathead slotted 4/40 screw, I can send you two.
For the d-ring I used the same 4/40 slotted brass screws just longer with washers/nuts on the inside of the Graflex. The head size is a little larger than the Kobold but if you've got a grinding wheel or a good file you can reduce the outer diameter easy and quick (brass melts like butter).
PM me your shipping address and I'll get them in a padded envelope headed your way.
http://images20.fotki.com/v355/photos/9/976173/4001324/39446002119820-vi.jpg
i have a few of them, but they are much larger i wonder where i can find that low profile miter box?
Halliwax,
I got my miter box and miter saw (they came together) at Michael's (here in the midwest in the U.S.).
My miter box is about 2 inches tall if my memory serves correctly. That should be a good estimate until I get mine unpacked from storage.
struggling with a Darth Vader costume for over a year now and a customer who promised to lose some weight to be able to fit yet he didn't :wacko
Chaim
Also, just got a Kobold clip from Roy - it's beautiful!
im hoping to place a order to roy in 2 weeks, we are so lucky to have him and his kobold's he makes!