differences in 95 dredd lawgivers?
- Thread starter ranallace
- Start date
Propsjonnyb
Well-Known Member
2 more hours of sanding - - hands tired ...LOL
- - - Updated - - -
if i drill into the hollow spots - visible in the trigger guard area - and use a syringe to shoot resin in that cavity will that make it more solid ?
Yes it will , I'd drop in a few lead shot fishing line weights then add the resin this should give the handle a lot more weight and the resin will solidify and stop thm rattling about
Last edited by a moderator:
ranallace
Well-Known Member
more pics .... working off the pics of the hero firing lawgiver on this page : Judge Dredd movie Lawgiver... anyone have one? in Guns Guns Guns! Forum i have designed changes in the resin to emulate that version - this will be phase 2 of my construction - this is turning into more of a build thread .....LOL
** I am more than 24 hours into this replica so far and havent even scratched the surface
-pics are self explanitory i think - crude drawings on the replica of where carving and detailing will take place
pics:
** in this photo i could use a half-side view of how the hammer and tail of the baretta fit under the slide - any help would be appreciated
**in this photo and the one after it a cut will be made to emulate the slide
** in this photo handle design will be changed to more closely emulate the baretta design
** here the slide release- metal bar thingie will be added
* and in this photo the backstrap area will be re-designed to the baretta look
** also planned is to cut and remove the magazine bottom and attach it to a baretta airsoft magazine and drill out handle area to accomidate it - still trying to work out how to keep it in there though
*** i'd also like to add a trigger in there , but need ideas as to how to go about that - was considering drilling up thru the current trigger guard and installing one that way - then skinning the guard with abs and doing a resin fill to solidify the area again - ideas on that ? comments ?
** I am more than 24 hours into this replica so far and havent even scratched the surface
-pics are self explanitory i think - crude drawings on the replica of where carving and detailing will take place
pics:
** in this photo i could use a half-side view of how the hammer and tail of the baretta fit under the slide - any help would be appreciated
**in this photo and the one after it a cut will be made to emulate the slide
** in this photo handle design will be changed to more closely emulate the baretta design
** here the slide release- metal bar thingie will be added
* and in this photo the backstrap area will be re-designed to the baretta look
** also planned is to cut and remove the magazine bottom and attach it to a baretta airsoft magazine and drill out handle area to accomidate it - still trying to work out how to keep it in there though
*** i'd also like to add a trigger in there , but need ideas as to how to go about that - was considering drilling up thru the current trigger guard and installing one that way - then skinning the guard with abs and doing a resin fill to solidify the area again - ideas on that ? comments ?
Last edited:
ranallace
Well-Known Member
ok found the milliput - got it in silver grey- not cheap 15 bucks .......got my epoxy .... ready to tackle that trigger area me thinks
size comparrison shots - rubber training baretta 92 , know its right size cause snaps into my retention holster , good snug fit
size comparrison shots - rubber training baretta 92 , know its right size cause snaps into my retention holster , good snug fit
Last edited:
ranallace
Well-Known Member
-any help on how to fill and shape the bubble holes on the corner edges ? i figure over 1000 views someones gotta be watching this - any help ?
Similar threads
