NycWallCrawler9

New Member
Hi everyone! I had a question about this Xcoser flash helmet I got (which will be shaped and painted) and the thing is it actually fits me PERFECT
...except for the chin...
The sides fit great but the chin comes out to far, I was wondering if anyone had any suggestions about making it fit right? I was thinking about maybe cutting the chin off and using a flexible material to put it back on somehow which I've seen other people do before. I attached a few photos of it below. If anyone has any ideas please comment, thanks!
 

Attachments

  • 20200817_152228.jpg
    20200817_152228.jpg
    742 KB · Views: 172
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top