Build your own Batmobile Tumbler

[joberg]

Here we work on the reinforcement frame. A fairly quick one too!

So many little screws...I'm always hoping that you didn't lose any during construction, that wouldn't be good

 

[chefhawk]

So many little screws...I'm always hoping that you didn't lose any during construction, that wouldn't be good

Its a lot and I am glad that I don't tend to loose any. Fingers crossed the buy mentioning it that it doesn't happen now.

 

[chefhawk]

Here we Add the Fireproof bulkhead to the metal frame and also add the afterburner too

 

[joberg]

Ah, gotcha! Was a little confused by the whole piece...but, when you turned it toward the camera, I could see the engine and get my bearings aligned once again

 

[chefhawk]

Glad you got your bearings...

Here we add some canisters and the inner bulkhead.

 

[joberg]

Glad you got your bearings...

Here we add some canisters and the inner bulkhead.

Good and solid work as always Question: are these canisters visible when everything is said and done?

 

[signeddiamond]

Very happy this kit just became available in Japan. I get to start next week!

 

[chefhawk]

Good and solid work as always Question: are these canisters visible when everything is said and done?

I would like to think they are slightly visible if nothing else.

 

[chefhawk]

Here we build a frame and add some connectors to the Front piece.Made a whoopsie that is revealed on the next video!

 

[chefhawk]

Here we add the floor frame and front section to the bulkhead. And by the devils hand this was a tricky one!.

 

[joberg]

You're right about that part Fiddly is not even the term!! Besides that, very good job putting it together

 

[chefhawk]

You're right about that part Fiddly is not even the term!! Besides that, very good job putting it together

Thank you. Very kind

 

[chefhawk]

Here we add some support struts and pistons the the front section. A bit of frustrated swearing also goes down!

 

[joberg]

Yeah...sometimes I wonder why the bulky wheels were affixed first when you have that little fiddly piece to cram in between wheel and chassis...But you've succeeded and the swearing is just part of letting steam off

 

[chefhawk]

Thank you for the comments Joberg.

Here we make a start on the engine panel