Source for a part that's similar to QGJ emitter?

Thread starter cayman shen
Start date Apr 11, 2008

cayman shen

Master Member

Apr 11, 2008

I've been looking at door lock trim rings and the like for a found metal part that's as close as possible to emitter on the TPM QGJ, OWK, council, etc. sabers. I want to try to scratchbuild a few of these sabers, and I'd need a ton of these beveled rings, so damned if I'm making this part from scratch every time!

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.