DoggieDoc
New Member
Hello all! I am a bit of a lurker here as I am much more active on the Sideshow Freaks forums making 1/6 scale accessories. However I was approached by a member there about making the detonator as seen in Guardians of the Galaxy: Vol. 2 to go alongside the baby Groot life sized figure.
Anyway, I am currently in progress on my build, having done this project from the ground up. I 3D modeled everything myself in Google Sketchup. I printed the majority of the parts on my Original Prusa i3 MKS2, and then fabricated the non printed parts and used off the shelf parts for things like wiring, lighting, etc. I also printed the buttons on my printer and, after some preparation molded them and cast them in red resin.
I don't have a TON of time to post the entire build quite yet, so I thought I'd add a few photos and then I can detail everything a bit later.
Anyway, I am currently in progress on my build, having done this project from the ground up. I 3D modeled everything myself in Google Sketchup. I printed the majority of the parts on my Original Prusa i3 MKS2, and then fabricated the non printed parts and used off the shelf parts for things like wiring, lighting, etc. I also printed the buttons on my printer and, after some preparation molded them and cast them in red resin.
I don't have a TON of time to post the entire build quite yet, so I thought I'd add a few photos and then I can detail everything a bit later.
Attachments
-
Groot detonator1.jpg138.8 KB · Views: 154
-
Groot detonator10.jpg71.3 KB · Views: 149
-
Groot detonator9.jpg70.8 KB · Views: 153
-
Groot detonator8.jpg91.8 KB · Views: 198
-
Groot detonator7.jpg32.2 KB · Views: 151
-
Groot detonator6.jpg30.6 KB · Views: 159
-
Groot detonator5.jpg39.2 KB · Views: 142
-
Groot detonator4.jpg30.2 KB · Views: 146
-
Groot detonator3.jpg119.3 KB · Views: 139
-
Groot detonator2.jpg106.6 KB · Views: 152