Jason Bourne Langley Star

iwalker

iwalker

New Member
Hey gang,

I am wanting to make Richard Webb's Langley Wall of Honor star casting that Heather Lee gives to Jason in the final scene. Anyone have any ideas about how to best go about doing this? I know the dimensions of the Wall of Honor stars are 2.25 inches tall by 2.25 inches wide by 0.50 inches deep.


Screen Shot 2017-06-03 at 2.11.10 PM.pngScreen Shot 2017-06-03 at 2.11.23 PM.png
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

J
Bourne Identity Bank Account Implant?
Replies
0
Views
268
JForce
J
PropsToHistory
Bourne Identity Burn Bag...But if it was WW2. With Adam Savage
Replies
1
Views
701
joberg
joberg
Doomed Gav
Jason Vorhees Friday the 13th Part 6 Dart replicas
Replies
2
Views
581
Odin82
Odin82
TopgunTech2
Star Fleet Research Startup & Phaser Prototype (TOS)
Replies
8
Views
413
Apollo
Apollo
Corellianexports
Star Trek TOS Phaser Build
Replies
11
Views
389
AJK001
A
Back
Top