Should have stuck with foam (1st attempt sculpting)

Thread starter spartacus1
Start date Jul 21, 2014

spartacus1

Member

Jul 21, 2014

I'm trying to sculpt a generic set of armor based loosely on:

This is the very beginning of the project:

This is obviously the very, very beginning of the project with a base outline. I have to add quite a bit and remove some from the base layer around the chest pieces.

Any tips from sculptors out there to get an even thickness and symmetrical parts?

Edit: Put this in wrong forum! Can a mod move this for me? Thanks!

Last edited: Jul 21, 2014

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.