Rysjin7717
Well-Known Member
Zookone, it's Lookin pretty nice bra can't wait ta see it finished.
Sent from my HTC Wildfire S using Tapatalk
Sent from my HTC Wildfire S using Tapatalk
RSloan76, I'm going to need to order more cordura fabric for parts than I need. Are you interest in sharing some of the stuff needed for the build?
Your muscles are looking good, are you using patent stretch spandex. I should receive the carbon vinyl on Thursday, I have some new progress photos this weekend.
In the meantime I worked on the center/back of the tactical vest. It was raised up a bit some i'm going to build this and lower back belt piece out of pep and fiberglass.
Half of the tactical belt back plate:
Center back section of tactical/flak vest:
That cosplay is pretty solid. Been working on mine still. Good new also, was able to secure tickets to Comic-Con Sd so working towards that for the completion target.
Minor update tonight. I got a few of the peps complete for the tactical vest and tactical belt back plates.
Question: Why and how do you pep it with it still built into the paper like that?
I was able to curve the piece without breaking it by securing the part from the middle on a foam buck and gradually heating each side with a heat gun - allowing gravity to form the shape as I worked around it.
UPDATE:
I need something thicker to make this cuff out of. I'm thinking a section of PVC pipe, but I feel like that will be too thick and bulky. What I really need is something that's about 1/8" thick that I can cut out, then shape into a cylinder. Any ideas? -Cheap would be good too.