Here you go mate
From my email many years ago
Here are some important tips for building the Snowspeeder:
To correctly understand the tips, please take a look to the pic I sent you with the name of the parts:
The thread of the bolt inside the pilots seat is standard camera thread. You can use a security camera stand
to exhibit the model.
1-The gunner console should be glued to the rear cockpit before gluing it to the fuselage.
2-You must glue the cockpit before gluing the Main Repulsor Units (the big parts where the guns start)
(Look at the pic for the parts names)
3-The Laser Generators have a resin cylinder at the tip that seem to be extra resin. They are not. They are
there for you to glue the bronze tubes over them.
4-You need to buy a KS 5/16 bronze tube for the guns. They should be 8,8 cms long.
6-The Guns body is longer than the space between the Main Repulsor units and the Laser Generator Units.
They need to be sanded at the base, were it connects to the Main repulsor unit. I did a first mold with
the exact size but they came out short every time I casted them.
7-Paint the control panels before gluing them to the fuselage. I sent you a pic of how I painted mine but
it is just to give you an idea.
8-Don't leave the decals too much time in the water, just a few seconds is enough. This printed decals, even though
they received a good cote of lacquer, tend to loose ink if they are left too long in the water. You've got extra decals
9-The cooling fins have slightly different sizes. The Harpoon Cooling fin goes in the middle, with 3 Large cooling fins
to each side, followed by two medium size fins and one small fin at the end.