Ok I found some 0.25 mm styrene sheet so I was able to do the missing armor plates !
Well I ran into a big problem, I was not able to vacform them over the F-14 tanks :s The rear panels were the biggest problem. So I cut thin strips and do like a ship hull
I added the last details : styrene chips, wires etc
Dont forget the styrene strips on the side of the 312T engine
These strips were part of the casting on the original so you have to do the same on the bottom too !
Some more wires...
One strip was missing on the Saturn stage so I added one in styrene.
I rebuilt the boxes that sit on the Saturn stage, the original were not tall enough. I also added a piece of styrene that is only on the Orange as far as I know.
Wires, styrene details etc...
More panels, too bad, it was to late when I noticed I was taking ref of the blue B for the upper panels :s I can live with that
Opposite side (the panels are right on this side) :
I did shot a light coat primer to see the imperfections :
Hmm can spot 2 tiny airbubbles on the leading edge of the wing that I need to fix !
Hope you like