Wand Company Phaser Battery

[mikewen2]

So as I was negligent and haven’t charged my Wand Co phaser in well over a year. Battery charged but ran out of charge in about 10 minutes. Also, the P2 won’t fire. All pins are intact but sometimes it fires sometimes it doesn’t. I had to constantly remove and then put P1 back in. Anyway, is there anyone here that would replace the battery for a fee?? I’m not technically skilled enough to do it.
Any advice would be appreciated. I’d hate for this to just become a static prop.
Thanks

 

[Nicksdad]

Yes, there is a guy named Eric Nagy on facebook that offers this service. I think he charges 125.00 and you just send him your hand
phaser.

 

[mikewen2]

Yes, there is a guy named Eric Nagy on facebook that offers this service. I think he charges 125.00 and you just send him your hand
phaser.

I’m not on FB anymore. Do you know if there’s another way to contact him? - Thanks!

 

[AnubisGuard]

Also, the P2 won’t fire. All pins are intact but sometimes it fires sometimes it doesn’t. I had to constantly remove and then put P1 back in.

My copy had this problem, as well as misfiring/not stopping firing. A little dielectric grease on the tips of the pins fixed it. Just be careful not to get any between the pins or it'll short.

 

[Nicksdad]

I’m not on FB anymore. Do you know if there’s another way to contact him? - Thanks!

You can email Eric here.
propdept@yahoo.com

 

[mrwax]

My copy had this problem, as well as misfiring/not stopping firing. A little dielectric grease on the tips of the pins fixed it. Just be careful not to get any between the pins or it'll short.

Good to know, mine does this sometimes too, I'll clean the contacts first and try some dielectric grease if it still misbehaves.