Thought I would also share this here....
For those 3D print enthusiasts.
I would buy blank Circuit boards, and get some really thin, or cut really thin tape and design three fake boards and stuff middle one with some blinky LEDs. Basically what they did for the last movie except they just went with Red.
Here us a treat. These are the ORIGINAL Boards from the first film. The first one had the three LEDS which were yellow and one red.
I will not post my custom circuits, as they are proprietary.
I still own one of the circuit boards, I had one of the two working sets made for the film, but sold them long ago.
I also own the production masters from the film.
Winston wasn't happy with the light effect, so when they did the insert shot, they added some more LEDS (RED) and blue/White. and darkened the room to make them look brighter. My repro was screen accurate, not production accurate. But it matched the look on film exactly and included a variable flash rate. It also glowed green when you charged it. I have considered another run, but there is just not enough interest to do it at a cost that would be manageable.