T-800 Skull help

[Sluis Van Shipyards]

I'm 3D printing a T-800 skull right now and I noticed that it does not have the parts that holds the jaw to the skull. Does anyone have a good picture of the detail there? I've found some pics of collectible versions, but the pictures aren't detailed enough to see anything other than it's some kind of round detail. And they vary.

 

[DalekNim]

Might want to look at a different model depending on how far along you are. Here's a pic of mine but the jaw just slotted into place in the skull, there were no pieces to hold it in place. It was very similar to how the lower jaw on a T-Rex i'm building attaches to the skull. The vertical pistons seen on each side of the face are just for show and do not contribute to holding the jaw in place

 

[Too Much Garlic]

This is how Quartz' unfinished SWS gift skull was done.

 

[IFA]

Sorry, wrong answer....

 

[Sluis Van Shipyards]

I'll have to take a picture of mine. I think it's maybe 95% accurate, maybe a little big, not sure. I found some screenshots and it looks like a round detail on the movie version. Mine has a more elongated indent that the round piece sets in (on the prop). I'm going to go ahead and finish it to test finishes, plus it looks cool, but will get a more accurate model eventually.