Supersculpey

D

Darth Domain

Well-Known Member
I'm sculpting a mag housing and clip specifically for the kenner blaster, i have been looking at different methods but though i would go with supersculpey and then use this for a master to make my mold. How good/flexible is sculpey to work with, can it be manipulated easy etc
Thanks
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top