Removing pre-installed lenses?

Thread starter batfan10
Start date Feb 7, 2024

batfan10

Sr Member

Feb 7, 2024

Any advice on if it's possible to remove pre-installed lenses? I got a mask that has some big lenses that don't look as good as the ones I 3d printed. So I was wondering if there is a way to remove them. I think they're super glued on

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.