Question about casting in urethane rubber

regisaugusto

Active Member
Hello fellow members!

Simply put, my question is: how is the process to make urethanre rubber castings (ex.: cowls and masks) without seam lines? What material is used as negative mold?

I'm familiar with latex and the use of plaster molds, and I learned how to avoid/correct seam lines. However, urethane rubbers like vytaflex 40 are tixotropic, which poses another difficulty. So, how is the process?

Thanks in advance.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top