Molding a Batman Cowl: Slush cast or 3 part mold with core?

Thread starter weaponx82
Start date Aug 11, 2011

weaponx82

Well-Known Member

RPF PREMIUM MEMBER

Aug 11, 2011

When I'm finished sculpting my cowl, should I do a slush cast type of mold or a mold using a core?

It will be sculpted on my own bust and I want to cast the cowl as a silicone piece.

Is it really worth the effort or necessary to do a mold with a core or will I be fine with a slush cast mold? I'm concerned about it fitting well.

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.