I started this sculpt awhile back and have been working on it here and there over the past few months.
This sculpt is based more on this pic:
I used a DP standard TK helmet as an armature but now that its bulked out its about the size of one of the more accurate TK helmets.
I will get this sculpt done and smooth it as best as possible and make a mold then do a cast and pull a hard copy to clean up real good to be my master then another master mold will be made to produce the final helmet.
Because there are so many variations of the Mcquarrie TK helmet sketches and usually only one angle of each I am going to take some creative liberties for the back of the helmet probably using the 3 3/4" Mcquarrie Stormy action figure to get some ideas.
This vesrion is very close to the Mcquarrie saber trooper pic you always see the only real differnce is the eye area.
Some liberties will be taken to make this wearable as I am also doing the full armor set in the near future.
I have finished bulking out the sculpt now I am sculpting in some details.There are still some symetrical issues which will be addressed later.
I have alot of other shots of this from the side etc. and will post those later.Its hard to take a pic of this green clay cause if you use flash it washes out everything.
The bottom of the jowels in the pics appear to big but its the angle of the pics.And like I said above this is an early stage sculpt.
I need to taper the jowels in toward the center a bit and bulk out the dome a bit more to make the proportions better.
This sculpt is based more on this pic:
I used a DP standard TK helmet as an armature but now that its bulked out its about the size of one of the more accurate TK helmets.
I will get this sculpt done and smooth it as best as possible and make a mold then do a cast and pull a hard copy to clean up real good to be my master then another master mold will be made to produce the final helmet.
Because there are so many variations of the Mcquarrie TK helmet sketches and usually only one angle of each I am going to take some creative liberties for the back of the helmet probably using the 3 3/4" Mcquarrie Stormy action figure to get some ideas.
This vesrion is very close to the Mcquarrie saber trooper pic you always see the only real differnce is the eye area.
Some liberties will be taken to make this wearable as I am also doing the full armor set in the near future.
I have finished bulking out the sculpt now I am sculpting in some details.There are still some symetrical issues which will be addressed later.
I have alot of other shots of this from the side etc. and will post those later.Its hard to take a pic of this green clay cause if you use flash it washes out everything.
The bottom of the jowels in the pics appear to big but its the angle of the pics.And like I said above this is an early stage sculpt.
I need to taper the jowels in toward the center a bit and bulk out the dome a bit more to make the proportions better.
Last edited: