-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
View attachment 674570
A little test print. Looks good so far but I need to make the walls a little thicker and then I can print a potential master in 0.1mm
The one in the picture is printed with 0.15mm
A little test print. Looks good so far but I need to make the walls a little thicker and then I can print a potential master in 0.1mm
The one in the picture is printed with 0.15mm
Similar threads
