Iron Man Mask!!!

Thread starter realvision
Start date Jun 25, 2013

realvision

New Member

Jun 25, 2013

Hello,

Several months ago, I decided to make a full Iron Man helmet from fiberglass resin, but due to lack of time and dedication, I left it sitting in the garage. Few days ago, I sliced off the face mask and attached some old sunglasses onto it and I was very happy with the results. Then I sprayed some primer on and hand painted it. The paint doesn't look that great since it's literally my first time painting with a brush. Later on, I think I'll actually use spray paint on it.

For some reason I cant attach pictures so I'll just link it to my imgur album.
Iron Man Half Mask - Imgur
Thanks for viewing.

Special thanks to
Darkside501st

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.