Interest Iron Giant 6" 3D Printed Kit

Very Very Interested. I have the Mondo piece, any size is a good size for this piece.
Ever think about doing the Bolt as well? :)
 
tripoli said:
Very Very Interested. I have the Mondo piece, any size is a good size for this piece.
Ever think about doing the Bolt as well? :)
Click to expand...
You have the Mondo one? :(
That was way out of my price range once they hit the secondary market.
I am envious.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Jack2155
PRICEDROP - 3D printed 1/6 Millennium Falcon Chair for Cockpit/Engr Stn with accurate Stool
Replies
14
Views
1,392
Jack2155
Jack2155
Kokanee
Limited Run SNW Phaser "Big Damn Hero" Kit Phase II
Replies
8
Views
599
Kokanee
Kokanee
Astyanax
Done / Completed NERF SCOUT TROOPER BLASTER Conversion Kit by Astyanax & AnubisGuard
Replies
14
Views
856
Astyanax
Astyanax
Kukulcan
Limited Run Warehouse 13 Farnsworth 'hero' kit - last one
Replies
14
Views
1,150
tmax
tmax
Kokanee
Limited Run Klingon Bat'leth Kit - Lasercut 10ga steel!!!
Replies
8
Views
739
Kokanee
Kokanee
Back
Top