Interested in creating a Russian Santa (father frost) statue display next year - advice needed

T

TexasHusker

New Member
Hello everyone! I have a huge entry area in my house with a 30 foot high ceiling, and next year I would like to have a large (6 feet) "statue" of the Russian version of Santa Claus ("Father Frost"). I have searched the internet and have found nothing like that to buy. I am wondering if I could simply buy a mannequin, a life-like santa full mask, and then put on a higher end Father Frost costume? If I took my time, could I make it look good?

Here is what I am aiming for. Do-able? suggestions? Thank you!

1610067752987.png
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

K
Bad Santa prop replicas?
Replies
0
Views
333
Kypropguy
K
Kaito3Designs
Advice on creating resin molds for vacuum forming. Replica Phantom of the Opera mask
Replies
2
Views
497
Mr Mold Maker
Mr Mold Maker
bladefans
Violent Night Santa ring?
Replies
2
Views
822
bladefans
bladefans
propmaster2000
Don't know if anyone is interested in this - Modern Props Inc. news
Replies
6
Views
767
propmaster2000
propmaster2000
D
Making a faux e-ink display?
Replies
2
Views
326
smithjohnj
S
Back
Top