I want to illuminate the pulse emitters on my Jimmiroquai DeathTrooper, and was curious if others had arrived at a best easy way of doing it.
The pulse emitters are made of a translucent green resin, so I am hoping that a single light source in each will diffuse properly.
I was just going to put together a simple circuit of two green LEDs/resistor/9V battery. Simple enough, and small enough to install in-helmet. However, I really don’t want to order the LEDs, 9V connectors or resistors in bulk on eBay when I only need 1-2 of each. It seems a waste.
Is there an easier way to get this done “off the shelf”? Or a better way than two LEDs?
The pulse emitters are made of a translucent green resin, so I am hoping that a single light source in each will diffuse properly.
I was just going to put together a simple circuit of two green LEDs/resistor/9V battery. Simple enough, and small enough to install in-helmet. However, I really don’t want to order the LEDs, 9V connectors or resistors in bulk on eBay when I only need 1-2 of each. It seems a waste.
Is there an easier way to get this done “off the shelf”? Or a better way than two LEDs?