I am offering custom fitted horizontal lightsaber stands with a Death Star panel design. They are individually printed for each hilt so that it slots in and is held perfectly level and is covered up as little as possible. I have a few variations printed and ready to go including for the Graflex 2.0 ESB/TFA config but can quickly design and print new ones if given measurements or I can guesstimate diameters from comparison pictures.
These are printed in black or white ABS and painted with a flat grey although they can be left bare for your own finishing techniques if so desired.
The stands are $15 each or $23 for two + 7.15 USA shipping (they juuust fit into a small USPS flat rate box)
Please Paypal tom@tomleech.com including your RPF name and shipping address and comment "Payment sent" here and include which saber they are for. If I don't have that saber on hand to measure I will PM you to discuss the new design.
These stands have been designed to position the saber exactly in the center of Pioneer Plastics' 13"x5 1/2" x 5" acrylic display case shown below. I got mine from Hobby Lobby:
http://www.hobbylobby.com/Crafts-Ho...es/13-x-5-1-2-x-5-Standard-Display-Case/p/906
The ones from Hobby Lobby are 12 bucks and do not have a mirrored base, I can order the mirrored base versions for around the same price but they can only be ordered in cases so I would need 8 people.
I can also add whatever design you want to the struts, either embossed or cut out:
Ok, I guess triple stands is where it's at
This is their current design:
This one is cut for ANH, ESB and TFA Graflexes but as with the other stands, they'll each be individually 3d printed so can be cut for whatever grips/diameter you want. The struts are around 130mm/5 inches apart.
The triple versions will be $30 each or $50 for 2 + shipping (I believe they'd be able to fit into a medium USPS Flat Rate box at $13.60 but will confirm before I ship anything out )
These are printed in black or white ABS and painted with a flat grey although they can be left bare for your own finishing techniques if so desired.
The stands are $15 each or $23 for two + 7.15 USA shipping (they juuust fit into a small USPS flat rate box)
Please Paypal tom@tomleech.com including your RPF name and shipping address and comment "Payment sent" here and include which saber they are for. If I don't have that saber on hand to measure I will PM you to discuss the new design.
These stands have been designed to position the saber exactly in the center of Pioneer Plastics' 13"x5 1/2" x 5" acrylic display case shown below. I got mine from Hobby Lobby:
http://www.hobbylobby.com/Crafts-Ho...es/13-x-5-1-2-x-5-Standard-Display-Case/p/906
The ones from Hobby Lobby are 12 bucks and do not have a mirrored base, I can order the mirrored base versions for around the same price but they can only be ordered in cases so I would need 8 people.
I can also add whatever design you want to the struts, either embossed or cut out:
Ok, I guess triple stands is where it's at
This is their current design:
This one is cut for ANH, ESB and TFA Graflexes but as with the other stands, they'll each be individually 3d printed so can be cut for whatever grips/diameter you want. The struts are around 130mm/5 inches apart.
The triple versions will be $30 each or $50 for 2 + shipping (I believe they'd be able to fit into a medium USPS Flat Rate box at $13.60 but will confirm before I ship anything out
)
Last edited:
