HELP!!!! How to display my 7x7 Allspark

propcollector

Sr Member
RPF PREMIUM MEMBER
I need some help to display my allspark cube...but need some ideas, I would like to have spin on one of its corners but I do no want to put any holes in it. And would like to do some kind of yellow led to make it glow or maybe blue....I don't know so I am asking the experts here....Please help.

Mark
 
Last edited:
I was planning on getting some acrylic robs cut so that they held the cube like this:

images


Then make a base and have the LEDs mounted below the rods so that the allspark was lit from underneath from the rods. I've just never gotten around to doing it.
 
You can try and track down a second hand display turntable, and have made or make a small clear acrylic base that will cup the corner of your choice.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top