dye sublimation with black dye

Thread starter mrush
Start date Aug 3, 2015

mrush

New Member

Aug 3, 2015

Apologies if this isn't the right place, couldn't really find a 'general' forum!

I plan on printing a (mostly) black suit on a 4 watch stretch lycra/spandex from Fabric On Demand. I have done quite a bit of research over the past few weeks. I've seen many people say that when their costume is fully stretched, the color fades out a bit. I believe the color of the fabric is white (I dont see an option to change it), so printing a black suit, I fear the white might show too much.

Is there anything that I can tell the printing company that would help reduce the fade, or any other suggestions?

Thanks!

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.